Foundations & Footings
Code-compliant structural concrete for Park City custom homes, additions, and commercial builds — engineered for Summit County soils, 36-inch frost depth, and mountain-altitude pour conditions.
Structural concrete
Your foundation holds up every wall, roof, and floor above it. A bad one cracks, settles, and drags structural problems into every trade that follows — and fixing it later costs more than pouring it right in the first place. That math doesn't move.
Jurgen Becker has been a Utah contractor since August 11, 1998. On Park City foundations, that means direct coordination with your GC, structural engineer, and Summit County inspector. Every footing and wall hits plan elevations, meets code, and cures out before the framer shows up.
New custom home in Deer Valley, an addition on an Old Town remodel, a commercial build at Kimball Junction — Summit handles the full foundation scope end to end: excavation coordination, rebar layout, anchor bolt placement, pour scheduling, cure.
Foundation services
Why foundations fail
Most foundation failures trace back to a handful of preventable mistakes. Jurgen has seen each of these on Utah job sites since 1998, and they get designed out of the plan before a shovel hits the ground.
Park City lots can show clay, decomposed granite, fill, and exposed bedrock on the same site. We verify bearing capacity and compact in lifts so footings sit on real ground, not organic fill or a loose re-grade.
A foundation wall that's half an inch off-level drags the framing crew into shim work for a week. We check elevations before the pour and during, so the framer lands on a true, level top of wall.
Reinforcement in the wrong position doesn't carry the load the engineer designed for. We place rebar per plan, verify anchor bolt locations against the sill-plate layout, and photograph the whole thing before the truck shows up.
Foundations loaded too soon never reach design strength. We cure properly, protect the pour through the critical 7-day window, and give the GC a realistic "safe to frame" date instead of an optimistic one.
Coordination
Foundation work isn't a solo act. We coordinate with the GC, excavation crew, plumber, and Summit County inspector so the project stays on schedule. Inspection windows get hit, documentation gets handed over, weather delays get flagged early. Your Park City build stays on track from footing to framing — not because we say so, but because Jurgen is the one making the calls.
Park City Conditions
Foundations in Park City face conditions that aren't a factor at lower Wasatch Front elevations. Summit County's adopted minimum frost depth is 36 inches — six inches deeper than the 30-inch baseline common across Utah Valley — and that depth gets enforced because the freeze line actually reaches it. Pours at 6,500 to 9,000 feet contend with a longer winter, sharper diurnal swings, and ground that can be frozen well into spring on north-facing lots.
Summit brings cold-weather pour protocols to every Park City winter job — cold-weather mixes, ground heaters, insulated blankets, and accelerated cure schedules. We design footings to meet or exceed the Summit County 36-inch frost depth, factor snow load into anchor placement and stem wall reinforcement, and coordinate cure timelines with your framer so the build doesn't lose a week to weather it could have planned around.
The numbers we pour to
Sheet R301.2(1) / Residential
Frost line depth
36inches
Minimum footing depth below finish grade in Summit County — six inches deeper than the Utah Valley baseline, and enforced because the freeze line reaches it.
Winter design temp
−7°F
The 99% heating-design temperature that drives our cold-weather mix selection, ground heaters, and insulated blanket protocols.
Seismic category
D / D1
Rebar schedules, stem wall reinforcement, and anchor bolt placement all assume D/D₁ loading from the start.
Wind design speed
115mph
Exposed Wasatch Back lots factor into anchor spacing and stem wall reinforcement on every plan.
Air freezing index
2500
IRC's thermal measure for frost-protection calculations. Park City's is among the highest in the state.
Weathering
Severe
The code classification that requires air-entrained mixes and ice-barrier underlayment on every residential job.
Where We Work
Footing and foundation work across Park City custom-home communities and commercial districts. Each neighborhood has its own build profile — tap through for details.
Contact Summit Concrete for foundation and footing work across Park City and Summit County. We'll review your plans and provide a detailed scope and timeline.